society for analytical and metrological systems


Sensor installation on Softening Control

A short video shows how a water hardness sensor on the Softening Control device is properly connected to the analysis unit.


The sensor is to be plugged straight into the socket on the device.
Then the metal ring has to be turned until it is easily but securely attached.

The pressure ring on the T-piece of the flow measuring chamber must be pressed down.
The sensor must then be pressed straight and firmly into the T-piece. The sensor tip must not be touched and thus damaged.
Please note that the sensor can be heard and felt.

At the same time, the plug connection has to be made very easily.
The firm and pressure-proof fit can be checked by gently pulling on the sensor.
This completes the installation of the sensor.